In a nutshell: Selecting a chassis is likely one of the most important steps when constructing a PC. It defines the system’s general profile and units limits on inside elements. In the event you can entry a 3D printer, this DIY ITX case, with its distinct early 2000s retro look, is a sweet-looking choice.
Modder WhoIsLudwig just lately launched a blueprint and information for a singular 3D-printed ITX PC case. The chassis can home respectable gaming PC elements with first rate cooling.
Dubbed the Kubic, this PC casing combines elements of sure early 2000s retro gadgets for a singular however nostalgic look. The modder claimed inspiration from the distinctive workstations launched by NeXT within the late 80s and early 90s. The highest deal with remembers two distinct cube-like gadgets from the 00s – Apple’s Energy Mac G4 Dice and the Nintendo GameCube.
The chassis is designed for ITX profiles to make it accessible to these with smaller 3D printers. He examined it on a Bambu A1 Mini, and it is printable on any mannequin with at the least 180 x 180 mm of mattress clearance.
On high of the ITX motherboard, the chassis can match a CPU warmth block and fan with a peak of as much as 100 mm. It helps any two-slot graphics card with a size of as much as 220 mm, primarily together with mainstream fashions just like the GeForce RTX 4060, Radeon RX 7600, or their direct predecessors. Builders can add as much as 4 2.5-inch drives.
The Kubic is proscribed to SFX energy provides. Modifying the design for an ATX PSU is not inconceivable, however it may introduce thermal compromises.
Chassis followers as much as 140 mm and 30 mm thick are supported and are probably non-obligatory for builders counting on built-in graphics quite than distinct GPUs. Nonetheless, the modder claims a single fan can stabilize a CPU at as much as 94 levels Celsius and a GPU at as much as 75 levels within the worst-case state of affairs. With an AMD Wraith Spire cooler and an Arctic P14 PWM PST fan, the modder’s AMD Ryzen 5 3600 and RX 6600 by no means exceeded 75 levels. The warmth consumption is on the underside, with the exhaust on the highest.
WhoIsLudwig posted detailed meeting directions at Autodesk Instructables and the required 3D printing file on Printables. He used PLA filament for the mission. Screws and a soldering iron are required.